Feeds:
Posts
Comments

Posts Tagged ‘sculpin’

Putting the Z-Axis switch to work. This little guy was enticed by a homemade sculpin pattern on the 6110. Skagit short 375 and 8 feet of T-8 were the ticket.

That 6110 has some meat down low. I’m thinking it could easily handle a bit more. I got caught up in one spot where the branches of every tree were in the way. In that case 20 feet of skagit head seemed a bit much. A chopped up 17 footer or so in the upper 300’s or low 400’s might just be the ticket. Who knows maybe shorter and heavier.

Time to check the classified section of the forums and see what I can dig up.

Advertisements

Read Full Post »